Hardware tools should not be used without maintenance. Otherwise, their service life will be shortened. Today, we will discuss the use and maintenance of pneumatic screwdrivers in the hand pliers selection.
The hand pliers selection is mainly used for tightening assembly, in industries such as automotive manufacturing, electronics, home appliances, automotive parts production, equipment maintenance, and aerospace. Precision, reliability, and durability are the functional criteria of hand pliers selection. The quality of rotating hand pliers selection depends on six aspects:
1. The performance of the built-in pneumatic motor (rotational power);
2. The metal materials and processing methods used for transmission mechanism components;
3. The processing accuracy of components and the assembly accuracy of the tool;
4. The innovation, optimization, and improvement of tool design and production;
5. Quality control;
6. Correct and reasonable usage.
The basic six key points for the operation and maintenance of hand pliers selection: 1. Correct gas supply system: The intake pressure at the tool's inlet (not the output pressure of the air compressor) is generally 90PSIG (6.2Kg/cm^2). Both too high and too low pressures will damage the tool's performance and lifespan. The intake must contain sufficient lubricating oil to allow the pneumatic motor inside the tool to be fully lubricated (a piece of white paper can be placed at the tool's exhaust to check if there is oil stain, which should be present normally). The intake must contain as little moisture as possible. It is inappropriate if the compressed air has not been dried by an air dryer.
2. Do not dismantle the tool's parts randomly and operate. This will not only affect the operator's safety but also cause damage to the tool.
3. If the tool has minor faults or cannot achieve its original function after use, it should not be used any further. It should be immediately checked.
4. Regularly (about once a week) inspect and maintain the tool, add grease (Grease) to the bearings and other rotating parts, and add engine oil (Oil) to the pneumatic motor area.
5. When using various tools, always follow all safety regulations and operation instructions.
6. Select the appropriate tool for work. Tools that are too large are likely to cause work injuries, while tools that are too small are likely to cause damage to the tool.
hand pliers selection https://www.veibertools.com/application-scenarios-for-pliers-products.html
